GE JCBP24, JCBP25, JCBP26, JCBP27, JCBP28, JCBP29, JCBP30, JCBP32, JCBP33, JCBP34, RCB735, RCB740, RCB745, RCB746, RCB790 Installation And Owner's Instructions page 47

Problem
Display goes blank
(on some models)
Display flashes
(on some models)
Unable to get the
display to show "SF"
(on some models)
Power outage,
clock flashes
(on some models)
"Burning" or "oily" odor
emitting from the vent
Strong odor
Fan noise
Drawer does not slide
smoothly or drags
Possible Causes
A fuse in your home may be
blown or the circuit
breaker tripped.
The clock is turned off so that it
does not show in the display.
Power failure.
Oven control pads were
not touched properly.
Power outage or surge.
This is normal in a new oven
and will disappear in time.
An odor from the insulation
around the inside of the oven
is normal for the first few times
the oven is used.
A cooling fan may automatically
turn on and off to cool
internal parts.
The drawer is out of alignment.
Drawer is over-loaded or load
is unbalanced.
What To Do
• Replace the fuse or reset the circuit breaker.
• See the Using the clock and timer section.
• Reset the clock.
• The BAKE and BROIL HI/LO pads must be touched at
the same time and held for 3 seconds.
• Reset the clock. If the oven was in use, you must reset
it by touching the CLEAR/OFF pad, setting the clock and
resetting any cooking function.
• To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the Using the self-cleaning
oven section.
• This is temporary.
• This is normal. The cooling fan will turn off and on.
• Fully extend the drawer and push it all the way in.
See the Care and cleaning of the range section.
• Reduce weight. Redistribute drawer contents.
ge.com
47