GE JCBP24, JCBP25, JCBP26, JCBP27, JCBP28, JCBP29, JCBP30, JCBP32, JCBP33, JCBP34, RCB735, RCB740, RCB745, RCB746, RCB790 Installation And Owner's Instructions page 46

Before you call for service...
Troubleshooting Tips
Problem
Excessive smoking
Oven door will not open
after a clean cycle
Oven not clean after
a clean cycle
Oven door will not
unlock (on models
with a door latch)
Self clean light (on
some models) blinks
when trying to set a
self clean cycle
Self clean light (on
some models) blinks
during self clean cycle
"Door" appears in the
display
(on some models)
"F—and a number or
letter" flash in the display
(on some models)
46
Possible Causes
Excessive soil.
Oven too hot.
Oven controls not properly set.
Oven was heavily soiled.
Oven is too hot.
The OVEN TEMP knob has not
been set to CLEAN when the
latch was moved to the right.
The latch was not moved to the •Move the latch to the right as far as it will go. See the
right when the OVEN TEMP knob
was set to CLEAN.
A power interruption occurred. •Turn the OVEN TEMP knob to OFF and move the latch
Self-cleaning cycle has been
selected but the latch handle
was not moved all the way
to the right.
Latch handle was moved to the
right but a program other than
self-cleaning was selected.
On models with a door latch,
if a function error code appears
during the self-cleaning cycle,
check the oven door latch.
You have a function error code.
If the function code repeats.
What To Do
• On models with touch pads, touch the CLEAR/OFF pad.
On models with an OVEN TEMP knob, turn it to OFF.
Open the windows to ridthe room of smoke. Wait until
the SELF CLEAN light goes off. Wipe up the excess soil
and reset the clean cycle.
• Allow the oven to cool below locking temperature.
• See the Using the self-cleaning oven section.
• Clean up heavy spillovers before starting the clean cycle.
Heavily soiled ovens may need to self-clean again or for
a longer period of time.
• Allow the oven to cool below locking temperature.
Do not lock the door with the door latch except when
using the self-clean feature.
•Set the OVEN TEMP knob to CLEAN. See the Using the
self-cleaning oven section.
Using the self-cleaning oven section.
to the left as far as it will go. Reset the range controls
to the desired settings. See the Using the self-cleaning
oven section.
•Move the latch handle all the way to the right.
• Move the latch handle to the right only when setting
the self-cleaning cycle.
• The latch may have been moved, even if only slightly,
from the locked position. Make sure the latch is moved
to the right as far as it will go.
• Touch the CLEAR/OFF pad. Allow the oven to cool for
one hour. Put the oven back into operation.
• Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.