GE EPM 3000P Instruction Manual page 33

Chapter 7 Global Meter Setup
To change the TIME DELAY FOR RELAY 1 OR RELAY 2, follow these steps:
PRESS MAX/MIN/LIMITS, AT ANY TIME, TO CANCEL BEFORE STORING THE LAST DIGIT OR SWITCH.
0.
MAX MIN
MAX/MIN PRINT
VOLTS AMPS
LIMITS PROG
Step 1:
a. Enter Group Level of Programming Mode
(see Chapter 6).
b. Press MAX/MIN/LIMITS until 0. appears.
c. Press VOLTS to activate the Group.
04
_
I2
MAX MIN
MAX/MIN PRINT
VOLTS AMPS
LIMITS PROG
Step 3:
a. Press VOLTS and two dashes appear in lower
display.
b. Press MAX/MIN/LIMITS and three dashes appear in
lower display.
c. Press PRINT/PROG for desired number.
•
Press PRINT/PROG once and the blank signifies a
zero.
•
Press PRINT/PROG twice and 1 appears.
d. Press VOLTS to store.
AC VOLTS
A B C A B C
I I I I I I
N N N B C A
AC AMPS
A B C N
LM1 LM2
PHASE
NEXT
AC VOLTS
A B C A B C
I I I I I I
N N N B C A
AC AMPS
A B C N
LM1 LM2
PHASE
NEXT
GE Industrial Systems
04.
060
MAX MIN
MAX/MIN PRINT
VOLTS AMPS
LIMITS PROG
Step 2:
To program Relay 1:
a. Press MAX/MIN/LIMITS until 04. appears in upper
display.
To program Relay 2:
a. Press MAX/MIN/LIMITS until 05. appears in upper
display.
Lower display indicates current Time Delays.
04.
I25
MAX MIN
MAX/MIN PRINT
VOLTS AMPS
LIMITS PROG
Repeat this procedure until desired value is entered.
Lower display indicates the current Time Delay.
See Chapter 12 to Exit.
AC VOLTS
A B C
A B C
I I I I I I
N N N B C A
AC AMPS
A B C N
LM2
LM1
PHASE
NEXT
AC VOLTS
A B C A B C
I I I I I I
N N N B C A
AC AMPS
A B C N
LM2
LM1
PHASE
NEXT
28