GE EPM 3000P Instruction Manual page 31

Chapter 7 Global Meter Setup
7.5 G 0, F
ROUP UNCTION
To change the SYSTEM CONFIGURATION SWITCH settings, follow these steps:
NOTE: PRESS MAX/MIN/LIMITS, AT ANY TIME, BEFORE STORING THE LAST DIGIT OR SWITCH.
0.
MAX MIN
MAX/MIN PRINT
VOLTS AMPS
LIMITS PROG
Step 1:
a. Enter Group Level of Programming Mode,
(see Chapter 6).
b. Press MAX/MIN/ LIMITS until 0. appears in
upper display.
c. Press VOLTS to activate the Group.
03 I
_ _
MAX
MIN
MAX/MIN PRINT
VOLTS AMPS
LIMITS PROG
Step 2:
a. Press PRINT/PROG until desired PACK appears.
b. Press VOLTS to begin Data Entry Sequence.
Three dashes appear in lower display.
7.6 G 0, F
ROUP UNCTIONS
The EPM3000P can be equipped with a relay option. Two relays are included in this option. The relays can be used in
computer controlled or dedicated alarm options.
The relays can be locked or unlocked through a computer (must have communication
COMPUTER
CONTROLLED option).
DEDICATED ALARM
The relays can be locked or unlocked using the meter's keypad or its measured inputs.
The computer cannot change the state of the relay.
Under GROUP 0, FUNCTIONS 4-5, time delay for the Relays 1 or 2 can be set between 0 - 255 seconds. This allows
conditions to exist for a specified time period before the relay or alarm activates. If a time greater than 255 seconds is
entered, the meter defaults to the maximum value of 255 seconds.
3 - P P
ROGRAMMING ROCEDURE
AC VOLTS
A B C A B C
I I I
I I I
N N N B C A
AC AMPS
A B C N
LM2
LM1
PHASE
NEXT
AC VOLTS
A B C
A B C
I I I I I I
B C A
N N N
AC AMPS
A B C N
LM2
LM1
PHASE
NEXT
4-5 - T D R
IME ELAY FOR
GE Industrial Systems
03.0
MAX MIN
MAX/MIN PRINT
VOLTS
LIMITS PROG
03.0 appears in upper display.
Lower display indicates current PACK 0 Switch
Settings.
03. I
MAX MIN
MAX/MIN PRINT
VOLTS
LIMITS PROG
Step 3:
a. Press PRINT/PROG to toggle the segments UP or
DOWN for desired setting.
b. Press VOLTS to store
See Chapter 12 to Exit.
1 & 2 (O NL)
ELAYS PTION
AC VOLTS
A B C A B C
I I I I I I
N N N B C A
AC AMPS
A B C N
LM1 LM2
PHASE
AMPS
NEXT
AC VOLTS
A B C A B C
I I I I I I
N N N B C A
AC AMPS
A B C N
LM1 LM2
PHASE
AMPS
NEXT
26