Figure 5-2. Main Rs-232 Config Page - Garmin GPS GNS 530 Installation Manual

SDI
Selection
Common
LNAV 1
LNAV 2
5.2.2 MAIN RS-232 CONFIG Page
Select the MAIN RS-232 CONFIG Page (see Figure 5-2).
If necessary, change the selectable RS-232 inputs and/or
outputs to match that of the equipment installed in the
aircraft.
CHANNEL INPUTS
Selection
Off
Arnav/ei-fuel
Crossfill
GDL 49
Icarus-alt
Ryan TCAD
Shadin-adc
Shadin-alt
Shadin-fadc
Shadin-fuel
WX-500
500 SERIES INSTALLATION MANUAL
P/N 190-00181-02
Description
Common long-range navigator (only 429 data with SDI=0 is used)
Number 1 (Pilot) long-range navigator. Only 429 data with SDI=0 or SDI=1
is used.
Number 2 (Copilot) long-range navigator. Only 429 data with SDI=0 or
SDI=2 is used.
Description
No unit(s) connected to input of this channel.
Serial fuel flow information from the following units:
ARNAV FC-10, FT-10
Electronics International FP-5L
Serial transfer of flight plans and user waypoints between two 500 Series
units
Serial data input for in-flight access to weather and messaging
Serial altitude data from the following units:
Icarus Instruments 3000, Sandia SAE5-35
Garmin GTX 327 Transponder
Traffic information from a Ryan TCAD 9900B Series system.
Serial air data information from the following units:
Shadin ADC 200, 200+, 2000
Serial altitude data from the following units:
Shadin 8800T, 9000T, 9200T
Serial air data and fuel flow information from the following units:
Shadin 9628XX-X Fuel/Air Data Computer
Serial fuel flow information from the following units:
Shadin 91204XM Digital Fuel Management System
Shadin 91053XM Digital Fuel Management System
JP Instruments EDM-700 or EDM-760 Engine Monitor
Lightning strike information from a BF Goodrich WX-500 Stormscope.

Figure 5-2. MAIN RS-232 CONFIG Page

Page 5-3
Rev G