Transducer - Furuno FE-700 Installation Manual

F type
Flush Mount Kit (F): OP02-79-1 (001-229-290)
No. Name
Cosmetic
1
panel
2 Hex bolt
Spring
3
washer
1. Prepare a cutout in the mounting location whose dimensions are 210 (W) x 194 (H) mm.
2. Attach the cosmetic panel (02-129-1041-0) to the display unit with four hex bolts (M6x12)
and four spring washers (M6).
3. Fix the display unit to the mounting location with four tapping screws (5x20).
S type
Flush Mount Kit (S):
No. Name
1 Fixing plate 02-129-1045-0
2 Wing bolt
3 Hex bolt
Spring
4
washer
5 Wing nut
1. Prepare a cutout in the mounting location whose dimensions are 194 x 194 mm.
2. Insert the display unit to the cutout.
3. Attach two fixing plates (02-129-1045-0) to the display unit with four
hex bolts (M6x12) and spring four washers (M6).
4. Screw six wing bolts (M4x30) to wing nuts (M4).
5. Fasten the display unit with six wing bolts and nuts.

1.3 Transducer

The installation of the transducer and the tank should be accomplished by a dockyard referring
to the installation drawings at the back of this manual. An example of transducer installation
method is also shown in paragraph 1.3.2.
Note: Discussions should take place and agreement reached with the dockyard for sufficient
reinforcement and watertightness of the hull to comply with the regulations concerned.
OP02-79-2 (001-229-300)
OP02-79-3 (001-229-310)
Type
02-129-1041-0
M6x12
M6
OP02-80 (001-229-320)
Type
M4x30
M6x12
M6
M4
Code no. Qty
100-279-270
1
100-279-280
100-279-290
000-162-897-1
4
0
000-158-855-1
4
0
Code no. Qty
100-279-300 2
000-804-799 6
000-162-897-1
4
0
000-158-855-1
4
0
000-863-306 6
4
Remarks
OP02-79-1:N3.0
OP02-79-2:2.5GY5/1.5
OP02-79-3:7.5GY7/2
Remarks