Radar Map Corrections; Radar Map Correction; Cursor Data Correction - Furuno FAR-28x7 Series Operator's Manual

5. VIDEO PLOTTER OPERATION
5.6

Radar Map Corrections

5.6.1

Radar map correction

When there is positional error between the radar screen and radar map marks
and lines, do the following to correct it.
1. With the cursor inside the effective display area, roll the wheel to display
"CHART ALIGN L=OFF / EXIT" in the guidance box.
2. Operate the trackball to align the radar map with the radar screen.
3. Push the left button to set. "MAN ALIGNED" appears at the right side of the
screen.
To release the radar map correction, display "CHART ALIGN L=OFF / EXIT" in
the guidance box and then push the left button until "MAN ALIGNED" disappears
from the screen.
5.6.2

Cursor data correction

You can correct cursor data as below.
1. Roll the trackball to choose the MENU box at the right side of the screen and
then push the left button.
2. Roll the wheel to choose 5 PLOTTER and then push the wheel or the left
button.
1 BACK
2 CHART COLOR*
3 OWN TRACK INTERVAL
4 OWN TRACK COLOR
5 TGT TRACK INTERVAL*
6 TGT TRACK COLOR*
7 CURSOR L/L ALIGN
8 [DATA ERASE]
9 [DISPLAY]
0 AUTO TARGET TRACK*
3. Roll the wheel to choose 7 CURSOR L/L ALIGN and then push the wheel or
the left button.
5-8
[PLOTTER]
GRN/YEL/CYA
ORANGE/GRAY
OFF/DRAW/10S/30S/
1M/2M/3M/6M/15M
RED/GRN/BLU/YEL/
CYA/MAG/WHT
OFF/DRAW/10S/30S/
1M/2M/3M/6M/15M
RED/GRN/BLU/YEL/
CYA/MAG/WHT
OFF/ON
OFF/ON
* Not available on IMO type
PLOTTER menu