Furuno 1715 Operator's Manual page 34

1. Turn on the power while pressing and
holding down the [MENU/ESC] key.
Continue pressing the [MENU/ESC] key
until the Installation menu appears.
INSTALLATION MENU
SIMULATION
TEST...
LCD PATTERN...
MEMORY CLEAR
NMEA PORT
NMEA OUTPUT
GPS WASS
GO TO RADAR SETUP...
Installation menu
2. Press ▼ to choose GOTO RADAR
SETUP.
3. Press ►. Power is then reset.
4. Wait one minute, press the
[POWER/BRILL] key followed by the
[MODE] key to transmit.
5. Press the [MENU/ESC] key to show the
User menu.
6. Press ► to show the Radar Setup menu.
RADAR SETUP
HEADING ADJUST
TIMING ADJUST
SET ON TIME
SET TX TIME
[MENU/ESC]: Exit.
Radar setup menu
7. HEADING ADJUST is selected; press ►
to show the options window.
RADAR SETUP
HEADING ADJUST
TIMING ADJUST
SET ON TIME
SET TX TIME
[MENU/ESC]: Exit.
Radar setup menu (heading adjust)
OFF
: IN/OUT
: OFF
: OFF
: 000000h
: 000000h
: YES
: NO
: 000000h
: 000000h
27
8. Press ▲ to choose YES, and the display
now looks as below.
Message
HEADING LINE ADJUSTMENT BY
' ' AND ' ' KEYS.
THEN PUSH MODE KEY TO SET.
Heading adjustment display
9. Visually identify a suitable target (for
example, ship or buoy) at a range
between 0.125 to 0.25 miles.
10. Point your boat's bow directly toward the
target selected at step 9.
11. Locate the target selected at step 9 on
the display and choose a range which
places it in the outer half of the picture.
12. Press ◄ or ► to bisect the target with the
heading line.
Heading adjustment display
13. Press the [MODE] key.
14. Press the [MENU/ESC] key to return to
the Installation menu.
15. Move the boat towards a small buoy and
confirm that the buoy shows up dead
ahead on the radar when it is visually
dead ahead.
3. INSTALLATION
Heading Line
Target
Heading Line