Related Manuals for Furuno 1731
Summary of Contents for Furuno 1731
- Page 1 Back...
- Page 2 9-52 Ashihara-cho, 9-52 Ashihara-cho, Nishinomiya 662-8580, JAPAN Nishinomiya 662-8580, JAPAN Telephone : Telephone : 0798-65-2111 0798-65-2111 0798-65-4200 0798-65-4200 Printed in Japan Printed in Japan All rights reserved. All rights reserved. Pub. No. OME-34450 Pub. No. OME-34450 ( ( TATA TATA ) ) MODEL1731MARK-3 MODEL1731MARK-3 The paper used in this manual is elemental chlorine free.
- Page 6 COMPLIANCE WITH R&TTE DIRECTIVE 1999/5/EC This radar complies with the R&TTE Directive 1999/5/EC. In accordance with Article 6-3 of this directive, FURUNO intends to put this radar on the market of the following countries in EU as well other markets.
- Page 8 This page is intentionally left blank.
- Page 11 Sweep timing ... 6-10 Relative bearing alignment... 6-12 MAG or GYRO indication... 6-14 Range unit selection ... 6-14 Magnetron heater voltage ... 6-15 MEASUREMENT OF BLIND SHADOW SECTORS ... 6-16 OUTLINE DRAWINGS ... D-1 INTERCONNECTION DIAGRAM...S-1 Declaration of Conformity Table of Contents...
-
Page 19: Equipment List
EQUIPMENT LIST Complete Set Name Antenna Unit Display Unit Spare parts Accessories Installation Material (Select one.) Installation Materials (CP03-180xx) Name Hex. Bolt Flat Washer Spring Washer Tapping Screw Socket Cap Signal Cable* (Select one.) Power Cable EMC Core S03-61 compatible may be supplied; two thin pink wires replaced with one thick wire. Accessories Name Hood Assy. - Page 24 Timer 1:29 FURUNO...
-
Page 64: Mounting The Antenna
(1) This signal cable run between the antenna and the display comes in lengths of 10 m, 15 m, 20 m and 30 m. whatever length is used it must be unbroken; namely, no splicing allowed. (2) Deposits and fumes from a funnel or other exhaust vent can adversely affect the aerial performance and hot gases may distort the radiator portion. - Page 65 Pan head screws M4x8 4 pcs. Cable clamping plate Shield cover Pan head screws M4x8 7 pcs. Shield cover Pan head screws M4x8 7 pcs. Antenna unit, inside view 7. Pass the cable through the hole at the bottom of the radome base. 8.
- Page 80 This page is intentionally left blank.