1.30 System Menu
The System menu mainly contains items
which once set do not require frequent
adjustment. You may display this menu by
choosing "SYSTEM MENU" from page 3 of
the User menu and then pressing ►.
PAGE 1
SYSTEM MENU
LANGUAGE
RANGE UNIT
DEPTH UNIT
SPEED UNIT
WIND UNIT
TEMP UNIT
NAV DATA
KEY BEEP
RINGS
WAYPOINT MARK
[MENU/ESC] : Exit.
SYSTEM MENU
PAGE 2
EBL REFERENCE
BEARING READOUT : TRUE
CURSOR POSITION : RNG&BRG
TRIP SOURCE
WIND SPD/DIR
SHIFT MODE
AUTO SHIFT SPEED : 15
TX SECTOR BLANK : OFF
BLANKING START
BLANKING AREA
LOCAL TIME SETUP : +0:00
ANTENNA SPEED
[MENU/ESC] : Exit.
SYSTEM MENU
PAGE 3
RANGE 0.125nm
0.25 nm
0.5
0.75 nm
1
1.5
2
3
4
6
8
12
16
24
[MENU/ESC] : Exit.
System menu
English
: nm
: ft
: kt
: kt
: °F
:
: ON
: OFF
: OFF
(1/3)
Page no.
TRUE
: LAT/LON
: APPARENT
: MANUAL
: 000°
: 000°
: AUTO
(2/3)
ON
: ON
nm
: ON
: ON
nm
: OFF
nm
: ON
nm
: OFF
nm
: ON
nm
: OFF
nm
: ON
nm
: ON
nm
: ON
nm
: ON
(3/3)
nm
: ON
System menu description
Page 1 of system menu
LANGUAGE: The system language is
available in English, several European
languages and Japanese. To change the
language, choose language desired, and then
press the [MENU/ESC] key.
RANGE UNIT: Chooses the unit of range
measurement among nautical miles,
kilometers and statute miles.
DEPTH UNIT: Chooses the unit of depth
measurement among meters, feet, fathoms,
Hiro (Japanese) and Passi/Braza. Requires
depth data.
SPEED UNIT: Chooses the unit of speed
measurement among knot, mile per hour and
kilometer per hour. Requires speed data.
WIND UNIT: Chooses the unit of wind
measurement among mile per hour, kilometer
per hour and meters per second. Requires
wind data.
TEMP UNIT: Chooses the unit of water
temperature measurement from Celsius and
Fahrenheit. Requires water temperature data.
NAV DATA: Chooses the amount of nav data
to display among two, three and four items.
Requires appropriate sensors.
KEY BEEP: A beep sounds to confirm valid
and invalid operation. You can turn this beep
on or off.
RINGS: Turns the range rings on or off.
WAYPOINT MARK:
The waypoint mark
shows the location
of the destination
waypoint set on a
plotter. You can turn
this mark on or off.
Requires a plotter.
16
1. OPERATION
Waypoint
mark
Waypoint mark