System Configuration - Furuno 2137S Installation Manual

SYSTEM CONFIGURATION

Performance Monitor
POWER SUPPLY
UNIT PSU-007
1)
EPFS
(Navigator)
2)
SDME
Speed Log
3)
Gyrocompass
AIS
Track Control Unit
MEMORY CARD
INTERFACE UNIT
CU-200-FAR
: Standard
: Option
: Dockyard supply
*: For FAR-2137S-BB, a monitor unit is prepared by user. See page 1-8.
These monitors have been approved by the IMO, MU-190/201CR for CAT2,
MU-231/231CR for CAT1. If a different monitor is to be used, its effective
diameter must meet the applicable Category requirements:
CAT 1: effective diameter 320 mm or higher, CAT 2: effective diameter 250 mm or higher
Refer to their operator's manuals for details.
**: Used for antenna cable more than 100 m.
***: Not available for HSC spec.
****: Contact output for Alarm
(Load current) 120mA, (Polarity) No.1/2: Normally Close, No.3/4: Normally Open
Serial I/O for alarm is also possible, which complies with IEC 61162-1.
1) Connect the EPFS which is approved in accordance with the requirements of the IMO in
resolution MSC. 112(73) is used.
2) Connect the SDME which is approved in accordance with the requirements of the IMO
in resolution MSC.96(72) is used.
3) Use the gyrocompass having an update rate that is adequate for the ship's rate of turn.
Radiator
SN30AF/
SN36AF
***
RU-5693
***
RU-6522
***
RU-5466-1
PROCESSOR UNIT
IEC-61162 Serial Data
(Input/Output)
IEC-61162 Serial Data
(Input)
Gyro Converter
AD-100
AC spec. only
ANTENNA UNIT
Chassis
RSB-098/099
RSB-100/101/102 (for HSC)
RJB-001 **
MONITOR UNIT
MU-201CR
MU-190
(FAR-2137S)
MU-231CR
MU-231
(FAR-2837S)
CONTROL UNIT
RCU-014
(Standard)
RCU-015
RJB-001 **
(Trackball)
Control Unit
RCU-016
(Remote)
RPU-013
Sub Display
Alarm****
GC-10
VDR
External Monitor
Transformer Unit
RU-1803
Category of Units
Antenna Unit: Exposed to weather
All other units: Protected from weather
v
*
or
or
or
100-230 VAC
Switching HUB
HUB-100