Pioneer GM-D8701 Owner's Manual page 10

Connecting the units
1 Route battery wire from engine com-
partment to the vehicle interior.
When drilling a cable pass-hole into the ve-
hicle body and routing a battery wire thor-
ough it, take care not to short-circuit the
wire damaging it by the cut edges or burrs
of the hole.
After completing all other amplifier connec-
tions, finally connect the battery wire terminal
of the amplifier to the positive + battery term-
inal.
2
1
1 Positive + terminal
2 Battery wire (sold separately)
The maximum length of the wire between
the fuse and the positive + terminal of the
battery is 30 cm (12 in.).
3 Fuse 100 A (GM-D8701 and GM-DX871) /
150 A (GM-D9701 and GM-DX971) (sold se-
parately)
Each amplifier must be separately fused at
100 A (GM-D8701 and GM-DX871) / 150 A
(GM-D9701 and GM-DX971).
2 Use wire cutters or a utility knife to
strip the end of the battery wire, ground
wire and system remote control wire to ex-
pose about 10 mm (3/8 in.) of the end of
each of the wires, and then twist the ex-
posed ends of the wires.
3 Connect the wires to the terminal.
Fix the wires securely with the terminal
screws.
3
Twist
10 mm (3/8 in.)
6
4
1 Battery wire
2 Power terminal
3 Ground wire
4 GND terminal
5 System remote control wire
6 System remote control terminal
7 Terminal screws
En
7
2
1
3
5