4. Dismount heat sink from chassis assembly by unfastening four screws on the ANLG
board and disconnecting the connector of the mini pin coaxial cable.
ANLG board
Mini pin connector
Mini pin coax. cable
5. Take off the mini pin coaxial cable from J2 on the GN-8091.
6. Open the lid of GR-7000A
7. Connect cable assy. S.FL2-2LP0.7-D-WHT (175) (supplied) to J1 of GR-7000A
4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for GP-1650W)
Handling of Coaxial Cable
Do not touch the connector with bare hands;
use gloves.
Use radio pincers to remove, and pull out
straightly.
Plug in connector straightly.
A
Heat sink
Chassis assembly
Screws X 4
GN-8091
17