Qualification Of Personnel; General Safety Instructions; Product- And Technology-Dependent Safety Instructions; Protection From Electric Voltage - Bosch rexroth MS2N03-A Operating Manual

12 / 72

Product- and technology-dependent safety instructions

2.2

Qualification of personnel

Any work with or on the described product may
only done by qualified or skilled personnel. For
the purpose of this manual, qualified personnel
means persons who are familiar with trans-
porting, installing, mounting, commissioning and
operating the components of the electrical drive
and control system and the associated hazards
and have an appropriate qualification for their
job.
All persons working on, with or in the vicinity
of an electrical system must be informed of the
relevant safety requirements, safety guidelines
and internal instructionsEN 50110-1:2013.
2.3 General safety instruc-
tions
Important! Please read all instructions before
motor installation.
Do not install or operate motors or components
of the electric drive and control system before
you have not carefully read all delivered docu-
ments.
Please observe the particular applicable national,
local and system-specific regulations, the safety
instructions in the documentation and the
warning and informative labels on the motors.
Improper use of the motors and failure to follow
the safety instructions in this document may
result in material damage, personal injury, elec-
tric shock or, in extreme cases, to death!
In the case of damage due to non-observance
of the safety notes, Bosch Rexroth assumes no
liability.
Applications for functional safety are only allowed
if the motors have the SI‑sign on the rating plate.
Bosch Rexroth AG
2.4 Product- and technology-
dependent safety instruc-
tions
2.4.1 Protection from electric
voltage
Work required on the electric system may only
be carried out by skilled electricians. Tools for
electricians (VDE tools) are absolutely necessary.
Before working:
•
Enable.
•
Secure against reactivation.
•
Ensure de-energization.
•
Ground and short-circuit.
•
Cover or shield any adjacent live parts.
After completing the job, cancel the measures in
reverse order.
Dangerous voltage occurs during operation!
Danger to life, risk of injury by electric shock!
•
Before start-up, connect the protective con-
ductors on all electric components according
to the connection plan.
•
Operation, even for short measuring pur-
poses is only allowed with fixed connected
protective conductor on the specified points
of the components.
MS2N
R911347581, Edition 05