Data 1 Output Setting; Data 1, 3 Output Setup Menu - Furuno GP-80 Installation Manual

DATA 1 output setting

1) Press [MENU] [9] and [3]. The DATA 1, 3 OUTPUT SETUP menu appears.
! "
2) Press or to select Data Fmt.
# $
3) Press or to select V1.5, V2.0 or IEC.
4) Press the [ENT] key. Talker ID appears in reverse video.
# $
5) Press or to select GP, LC or DE.
6) Press the [ENT] key.
7) Enter Tx interval for each output data sentence in line 1. Tx interval is available in 00,
01, 02, 03, 04, 05, 06, 10, 15, 20, 30, 60, and 90 sec.
8) Press the [ENT] key.
9) Enter Tx interval for each output data sentence in lines 2 through 5. Press the [ENT] key
after setting each line.
In great circle calculation, BWC and WNC are output but BWR and WNR are not. In rhumb
line navigation, BWR and WNR are output but BWC and WNC are not.
The total data output are shown by percentage on the third line.
For best results the total output should be less than 90%; lengthen the Tx interval of less
important data to make the total output less than 90%.
DATA 1, 3 OUTPUT SETUP
Data Fmt. V1.5
Talker ID
Output Data (00-90 sec)84%
1. AAM:00 APA:00
2. BWC:00 BWW:00 GGA:01 GLL:00
3. RMB:01 RMC:01 VTG:01 WCV:00
4. WINC:00 WPL:00 XTE:00 ZDA:01
5. GNS:00 ZTG:000 Rnn:00 RTE:00
DATA3. Log Pulse
ENT : Enter
Settings shown here are default settings.
This line appears only when LOG is
selected by internal jumper wires.
Figure 5-1 DATA 1, 3 OUTPUT SETUP menu
V2.0 IEC
GP LC DE
APB:01 BOD:00
200ppm
400ppm
MENU : Escape
5. INITIAL SETTINGS
13