Switching Waypoint - Furuno 520 Operator's Manual

3. STEERING MODES
3.3.3

Switching waypoint

When you arrive at a waypoint on a route while in the NAV mode, you can switch
to the next waypoint automatically or manually. The AUTO setting will
automatically switch to the next destination waypoint when your boat is within
the arrival alarm area (set on the plotter). The MANUAL setting requires operator
confirmation (pressing the course control knob) before switching to the next
waypoint. When in MANUAL switching mode, the NAVpilot-511/520 will sound
for five seconds an alarm when the vessel arrives at the destination waypoint.
AUTO:
MANUAL:
1. In the NAV mode, press the [TURN/MENU] key twice to show the NAV mode
menu.
2. Rotate the course control knob to select "WAYPOINT SWITCHING" on the
second page.
3. Press the course control knob to show the waypoint switching window.
4. Rotate the course control knob to select AUTO or MANUAL as appropriate.
5. Press the course control knob and [TURN/MENU] key in order to close the
menu.
3-6
When your boat is within the arrival alarm area, the buzzer sounds
for five seconds and the message "WPT WAS CHANGED"
appears.
The message "WPT WAS CHANGED." appears when the vessel
arrives at the destination waypoint.
Waypoint switching options window
AUTO
MANUAL