Automatic Digital-Source Synchro Recording; 1-Track Recording - Fostex CR300 Owner's Manual

AUTOMATIC DIGITAL-SOURCE SYNCHRO RECORDING

A. 1-track recording
When the source equipment starts to play, only one track is recorded automatically and the
recording stops automatically after that track. This mode is convenient for edited recording
of a CD, DAT, MD or DCC(only S/P DIF).
After loading the disc, check that
the CD-R or CD-RW indicator stops
blinking and starts to light steadily.
In case it does not light steadily,
refer to page 42.
• The AES/EBU digital input cannot be
recorded with this function.
• The ANALOG input cannot be recorded
with this function.
• Confirm the track to be recorded before
recording.
• Every time the DIGITAL SYNCHRO
button is pressed, the mode is changed
in order of 1-SYNC AL-SYNC
Record-pause mode.
Select "AL-SYNC" when all-track
recording is required.
• Do not start the playback of the
source player until the SYNC
indicator starts to blink.
• If the SYNC indicator is not lit after 1-
track synchro recording, the track to be
recorded next can be confirmed on the
source player.(Automatic recording
cannot be started while the SYNC
indicator is not lit.)
SYNC indicator is not lit.
18
CR300 <PRB1291-A>
1 4 2
7
1
Load a CD-R or CD-RW
disc containing a record-
able space.
For a disc loading, refer to page 15.
2
Set the INPUT SELECTOR
to DIGITAL.
Select OPTICAL or COAXIAL.
3
Ensure that the source player is not playing (in stop or pause
mode).
• This function cannot be activated if the source is being played.
4
Press the DIGITAL
SYNCHRO button.
• Check the copy bit indicator
(refer to page 24).
5
Start playing the source player.
• This unit starts recording automatically.
• The SYNC indicator is flashing (1-track synchro recording standby), or during 1-track
synchro recording, if the input signal is interrupted or the source is switched to a source
for which auto synchro recording is not possible, the 1-track synchro recording mode will
be canceled and the unit will enter the record-pause mode.
6
If the track changes (when input source is CD or Mini Disc), or
if the next start ID is detected (when input source is DAT or
DCC), 1-track recording will be cancelled and the unit will en-
ter the record-pause mode. The 1-track recording mode is also
cancelled if no signal (less than -90dB) condition lasts for
the length set by the MENU button functions.(See page 24)
• If it is required to record another track after 1-track recording, repeat steps 3 to 5 again.
7
After recording, press the stop ( )
button to end recording.
"PMA REC" is displayed and the unit
stops after recording the track data.
REC
TRACK NO.
FADER
WREITE
REPEAT
Label side
INPUT SELECTOR
DIGITAL ANALOG
XLR / +4
•
COAX XLR / -10
•
•
OPT • • LINE
AES / •
EBU
Wait until the SYNC indicator blinks.
Blinks