Mercedes-Benz A Series 2015 Owner's Manual page 345

Flat tyre
342
If you come into contact with the tyre sealant,
observe the following:
Rinse off the tyre sealant from your skin
R
immediately with water.
If the tyre sealant comes into contact with
R
your eyes, immediately rinse them thor-
oughly with clean water.
If tyre sealant is swallowed, immediately
R
rinse your mouth out thoroughly and drink
plenty of water. Do not induce vomiting,
and seek medical attention immediately.
Immediately change out of clothing which
R
has come into contact with tyre sealant.
If an allergic reaction occurs, seek medical
R
attention immediately.
! Do not operate the tyre inflation com-
pressor for longer than ten minutes at a
time without a break. It may otherwise
overheat.
The tyre inflation compressor can be oper-
ated again once it has cooled down.
Comply with the manufacturer's safety
instructions on the sticker on the tyre infla-
tion compressor.
Using the TIREFIT kit
Do not remove any foreign objects which
X
have penetrated the tyre, e.g. screws or
nails.
Remove the tyre sealant bottle, the accom-
X
panying TIREFIT sticker and the tyre infla-
tion compressor from the stowage well
underneath the luggage compartment floor
( page 339).
Y
Affix part : of the TIREFIT sticker to the
X
instrument cluster within the driver's field
of vision.
Affix part ; of the TIREFIT sticker near the
X
valve on the wheel with the defective tyre.
Remove filler hose B and connector =
X
from the bottom section of tyre inflation
compressor housing ;.
Slide the yellow filler hose connector into
X
the mounting on yellow cap A of tyre seal-
ant bottle : until the connector engages.
With the sealing rings in front, slide yellow
X
cap A of tyre sealant bottle : into the
holder of tyre inflation compressor ;.
Yellow cap A and both hooks must
engage.
Remove the cap from valve C on the faulty
X
tyre.
Screw filler hose D onto valve C.
X
Insert plug = into a 12 V socket in your
X
vehicle.