Mercedes-Benz A Series 2015 Owner's Manual page 126

Vehicles with Adaptive Highbeam Assist:
when Adaptive Highbeam Assist is active, it
controls activation and deactivation of the
main-beam headlamps (
Headlamp flasher
To switch on: turn the key in the ignition
X
lock to position 1 or 2, or start the engine.
Pull the combination switch in the direction
X
of arrow =.
Hazard warning lamps
To switch on the hazard warning lamps:
X
press button :.
All turn signals flash. If you now switch on a
turn signal using the combination switch,
only the turn signal lamp on the corre-
sponding side of the vehicle will flash.
To switch off the hazard warning lamps:
X
press button :.
The hazard warning lamps switch on auto-
matically if:
an airbag is deployed or
R
the vehicle decelerates rapidly from a
R
speed of above 70 km/h and comes to a
standstill
The hazard warning lamps switch off auto-
matically if the vehicle reaches a speed of
above 10 km/h again after a full brake appli-
cation.
The hazard warning lamps continue to oper-
ate even if the ignition is switched off.
page 123).
Y
Adaptive Highbeam Assist
General notes
You can use this function to set the head-
lamps to change between dipped beam and
main beam automatically. The system recog-
nises vehicles with their lights on, either
approaching from the opposite direction or
travelling in front of your vehicle, and conse-
quently switches the headlamps from main
beam to dipped beam.
The system automatically adapts the dipped-
beam headlamp range depending on the dis-
tance to the other vehicle. Once the system
no longer detects any other vehicles, it
switches on the main-beam headlamps again.
The system's optical sensor is located behind
the windscreen near the overhead control
panel.
Exterior lighting
Z
123