Siemens SIMATIC NET RUGGEDCOM RX1510 Installation Manual page 30

CAUTION
Configuration hazard – risk of data corruption/loss. Do not remove or insert the CF
card when the device is powered on.
The CF card should only be removed in the following scenarios:
• The chassis is defective (with the exception of power and media modules)
• The CF card is deemed defective or corrupt
• The device is rendered non-functional due to a serious configuration error, data
corruption, or hardware fault
CAUTION
Configuration hazard – risk of data corruption/loss. The following will void the war-
ranty and potentially result in configuration data corruption/loss:
• Using a CF card not approved by Siemens for use with this device
• Removing the CF card in any scenario other than those described in this section
Inserting the CF card
To insert the CF card into the device, do the following:
NOTICE
The device should only be powered on when the CF card is present.
1. Make sure the device is powered down.
2. Remove the CF card access panel.
RUGGEDCOM RX1510
Installation Manual, 12/2019, C79000-G8976-1055-16
All manuals and user guides at all-guides.com
Device Management
3.3 Accessing the CompactFlash Card
21