Table of Contents
Advertisement
907423 - 10-05-02.qxd
FAILURE TO START
Should your tool fail to start, check to make sure the prongs on the cord plug
are making good contact in the outlet. Also, check for blown fuses or open
circuit breakers in the line.
LUBRICATION
Although all Porter-Cable tools have been thoroughly lubricated with a
sufficient amount of high grade lubricant at the time of manufacture, it is
recommended that the oil level in the gear chamber be checked before using
your saw and periodically thereafter as follows:
1.
CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2.
Remove saw blade to prevent accidentally contacting it while checking oil
level.
3.
Adjust saw for maximum depth of cut and 45 degree bevel cut. Firmly
tighten all knobs.
4.
Turn on saw and run for approximately two minutes.
5.
CAUTION: DISCONNECT SAW FROM POWER SOURCE.
6.
Loosen oil plug (A) Fig. 12 with wrench provided.
7.
Remove oil plug and seal. Set saw on a level surface so it rests on points
(A) and (B) as shown in Fig. 13.
8.
Gear lubricant should be level with the bottom of the hole (C) but should
not run out. If this condition does not exist, add a small amount of lubricant
(90 weight gear oil) furnished with your saw until it is even with the bottom of
the hole.
9.
NOTE: DO NOT OVERFILL. If you do, the pressure created by the
pumping action of the gears may force lubricant through the seals and into the
motor chamber and cause damage to the motor.
10. Install oil plug and gasket.
A
Fig. 12
BRUSH INSPECTION AND LUBRICATION
For your continued safety and electrical protection, brush inspection and
replacement on this tool should ONLY be performed by an AUTHORIZED
PORTER-CABLE SERVICE STATION or a PORTER-CABLE/DELTA FACTORY
SERVICE CENTER.
10/22/02
2:10 PM
Page 12
12
C
A
Fig. 13
B
Advertisement
Table of Contents
