Table of Contents
Advertisement
907423 - 10-05-02.qxd
Install flat washer and thumb nut to stud (do not tighten). Adjust guide for
desired width of cut, taking into consideration the blade thickness and set.
Tighten thumb nut firmly.
CAUTION: Never use your saw if the telescoping guard is not in
working order. If telescoping guard movement is sluggish or binding
exists, return the saw to your nearest AUTHORIZED PORTER-CABLE
SERVICE STATION or PORTER-CABLE SERVICE CENTER FOR
REPAIR.
WARNING: It is important to support the work properly and to hold
the saw firmly to prevent loss of control which could cause personal
injury. Figure 6 illustrates typical hand support of the saw.
TO FOLLOW THE LINE OF CUT
A notch is provided on the front
edge of the base (Fig. 7) to assist in
following the line of cut marked on
the work. The left edge of the notch
is marked "45" and is used to follow
the line when making 45 degree
bevel cuts. The right edge of the
notch is marked "0" and is used to
follow the line when making 90
degree cuts. A little practice on
scrap material will indicate the
relation of actual cut produced to
the marked line. This knowledge is
required to produce accurate work.
10/22/02
2:10 PM
Fig. 5
HOW TO USE THE SAW
9
Page 9
Fig. 6
Fig. 7
Advertisement
Table of Contents
