Subaru Crosstrek Hybrid 2022 Owner's Manual page 66

62
Charging
6. Confirm that the charging indicator
illuminates.
NOTE
. During charging, the Driver Assist
indicator at the top of the combination
meter also blinks. This lighting can be
turned off. Refer to "Driver Assist
Indicator" FP221.
. If the charging indicator does not
illuminate when the charging connec-
tor is inserted, refer to "When normal
charging cannot be carried out" FP69.
. If the charging indicator blinks after
connecting the charge cable, the
charge schedule is registered and
charging cannot be performed immedi-
ately. To cancel the timer and start
charging immediately, perform any of
the following procedures.
– Turn "Charge Now" on. Refer to
"Setting the Remote Battery Char-
ging Timer" FP66.
– While the charging indicator is
blinking, remove and reconnect the
charging connector within 5 sec-
onds.
. If the error warning indicator on
Charging Circuit Interrupting Device
flashes during charging, refer to "When
a malfunction occurs during charging"
FP55.
The charging indicator will turn off when
charging is completed.
7. To lock the charging connector, carry
an access key fob and press the charge
cable connector lock switch.
NOTE
. After the charging connector is
locked, the charging connector cannot
be unlocked by pressing the charge
cable connector lock switch.
. When the charge cable is connected
to the charge port, the driver assist
indicator will indicate the charging
status by illuminating and blinking.
. If the latch release button is pressed,
charging will not begin even if the
charge cable is connected.
Also, charging will be stopped when
the latch release button is pressed and
held for several seconds during char-
ging. To restart charging, reinsert the
charging connector after pulling it out
and check that the charging indicator
illuminates.
. The surface of Charging Circuit
Interrupting Device may become hot
during charging, but this does not
indicate a malfunction.
. Depending on radio wave condi-
tions, interference may be heard on
the radio during charging.
. When the charging connector can-
not be inserted into the charge port,
refer to "Changing the charging con-
nector lock settings" FP52.