Subaru Crosstrek Hybrid 2022 Owner's Manual page 161

In such a case, perform the procedure
described in "Locking and unlocking"
FP404.
. The doors may lock or unlock when
the car is being washed or exposed to a
significant amount of water that con-
tacts the door handle while the key fob
is still in the operating range.
! How to lock and unlock
It is possible to perform the following
operations when you are carrying the
access key fob.
. Lock and unlock the doors (including
charge port door).
. Unlock and lock the rear gate.
NOTE
. It is not possible to lock the doors
and rear gate using the keyless access
function when the push-button ignition
switch is in the "ACC" or "ON" position.
Refer to "Switching power status"
FP188.
. If the door handle is gripped with a
gloved hand, the door lock may not be
released.
. If the door lock sensor is touched
three times or more repeatedly, the
system will ignore the sensor opera-
tion.
. When performing the locking proce-
dure too quickly, locking may not have
been completed. After performing the
locking procedure, it is recommended
to pull the REAR door handle to confirm
that the doors have been locked.
. If any of the doors (or the rear gate)
are not fully closed, the following will
occur to alert you that the doors (or the
rear gate) are not properly closed.
– An electronic chirp sounds five
times.
– The hazard warning flashers
flash five times.
. It is possible to lock the doors even
when one of the doors is open. After
performing the locking procedure,
close the opened door or rear gate to
lock it.
. Within 3 seconds after locking the
doors and the rear gate by using the
keyless access function, it is not pos-
sible to unlock doors and/or the rear
gate by using the keyless access func-
tion.
. When locking, be sure to carry the
access key fob to prevent locking the
access key fob in the vehicle.
. The setting of the hazard warning
flasher operation and the volume of the
audible signal can be changed by your
SUBARU dealer. Contact your SUBARU
Keyless access with push-button start system
dealer for details. Also, the setting of
the hazard warning flasher operation
can be changed by operating the com-
bination meter display (color LCD). For
details, refer to "Keyless Entry System"
FP221.
! Locking with the door lock sensor
1) Door lock sensor
Carry the access key fob, close all doors
including the rear gate, and touch the door
lock sensor on the door handle. All doors
including the rear gate will be locked. Also,
an electronic chirp will sound once and the
hazard warning flashers will flash once.
157
– CONTINUED –