Table of Contents
Advertisement
Checking/Adjusting
Extension Parallelism
(G0947)
The Model G0947 infeed and outfeed table exten-
sions can be adjusted for parallelism if necessary.
This process is the same for both table extensions.
IMPORTANT: The following steps are intended
to be performed directly after the steps involved
in Checking/Adjusting Table Parallelism begin-
ning on Page 39. DO NOT continue until you have
performed those steps.
Items Needed
Straightedge 24" ................................................ 1
Hex Wrench 4mm .............................................. 1
To check/adjust table extension parallelism:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen (2) table extension knobs and fully
extend table extension (see Figure 51).
Collar (1 of 2)
Table Extension
Knob (1 of 2)
Figure 51. Location of table extension
components.
Model G0945/G0946/G0947 (Mfd. Since 06/21)
Qty
Leveling
Access
(1 of 2)
Leveling
Leveling Collar
Lock Screws
3.
Place straightedge in the positions shown
in Figure 52. In each position, straightedge
should touch table extension handle and sit
flat on table.
— If straightedge just touches table exten-
sion handle and sits flat on table in all
positions, then table extension is already
parallel with table. Proceed to Step 5.
— If straightedge does not touch table exten-
sion handle and sit flat across table in any
of the positions, then table extension is not
parallel with table. Proceed to Step 4.
Black Lines Represent
Straightedge Positions
From Overhead View
Figure 52. Straightedge positions for checking
infeed/outfeed table extension parallelism.
4.
Loosen (2) leveling collar lock screws under
handle (see Figure 51), then use a hex
wrench inserted in the leveling access hole to
rotate leveling collar until handle just touches
straightedge.
— If straightedge touches table extension
handle, tighten leveling collar lock screws
and repeat Step 3.
— If straightedge does not touch table exten-
sion handle, then table extension is not
parallel with table. Repeat Step 4.
5.
Retract table extension and tighten (2) table
extension knobs.
-43-
Advertisement
Table of Contents
