CAUTION
Step 7. On the Processor Extender Board, set the IPF/PA switch to the IPF position. Refer to Figure 4-4,
"Processor Extender Board Switches."
Figure 4-4 Processor Extender Board Switches
Enabling the Onboard VGA
To enable the onboard VGA, perform the following steps:
Chapter 4
Upgrade Procedures for 1.5 GHz (A9731AX) or 1.6 GHz (A9732AX or A9733AX) Dual Processors
Do not overtighten the 6 shoulder screws—they may shear off if overtightened. Stop
tightening the shoulder screws when you feel them just bottom out.
Set switch to IPF
Introduction
55