Installing Server Components; Verification Of Upgrade Installation; Figure 4-6 Vga Port Cover Panel - HP 9000 rp4440 Upgrade Manual

A7124a to ab383a configuration a7134a to ab383a configuration

Hide thumbs Also See for 9000 rp4440:

Table of Contents

Step 2. Remove the two screws securing the VGA port cover from the rear panel as shown in Figure 4-6,

"VGA Port Cover Panel.".

Installing Server Components

Install the following components in the server chassis:

Step 1. Install the center hot-swap chassis fan unit. See "Installing a Hot-Swap Chassis Fan Unit" on

page 22.

Step 2. Install the processor extender board. See "Installing the Processor Extender Board" on page 20.

Step 3. Install the front and top covers. See "Installing the Top Cover" on page 17 and See "Installing the

Front Cover" on page 15.

Step 4. Install the front bezel. See "Installing the Front Bezel" on page 13.

After completing the upgrade, verify that the sever is ready for operation as follows:

Step 1. Reconnect AC power to rear panel connectors.

Step 2. Press the front panel power switch to power on the server.

Step 3. Wait for completion of the power-on-self-test. Verify that no errors have been detected.

Step 4. Answer Yes to prompts regarding copying system information between primary and secondary

locations.

Step 5. Boot the EFI shell.

Step 6. At the EFI shell prompt, enter the Info CPU command. Verify that all newly installed processors

are recognized and are responding correctly.

PROCESSOR MODULE INFORMATION

Chapter 4

Upgrade Procedures for 1.5 GHz (A9731AX) or 1.6 GHz (A9732AX or A9733AX) Dual Processors

VGA Port Cover

Introduction

Table of Contents

Integrity rx4640