Singer SGR-20420 Instruction Manual page 9

Two beeps will be heard.
5. Place the iron on the "Calc Clean" container (13). Make sure that the surface
on which the container is placed is stable.
WARNINGS:
Do not remove the iron from the container until the process has fi nished.
Boiling water and steam will be released through the soleplate, removing
limescale and/or deposits that may be inside.
The container must only be used to perform the descaling process. It
must not be used as a stand for the iron while ironing.
6. Press the steam release button (12) for 2 seconds. The descaling process
will start automatically. During this process, short beeps will be heard.
7. After approximately 3 minutes, the iron will stop releasing steam. A long beep
will be heard, indicating that descaling process has fi nished. The appliance
will switch off automatically.
8. To clean the soleplate (11), immediately rub off any residue by running the
hot iron over a wet cotton cloth. Wipe the housing of the iron with a cloth.
WARNING: The container gets hot during the descaling process.
9. Let it cool down and then empty the container.
2. Cleaning the appliance
Regularly clean your appliance for properly maintenance.
ATTENTION! Burn risk!
1. If the appliance is only slightly soiled, wipe it with a damp cotton cloth only,
and then dry it.
2. To keep the soleplate smooth, you should avoid contact with hard metal
objects. Never use a scouring pad, or chemicals to clean the soleplate.
3. Storing the appliance.
1. Unplug the appliance and let it cool down. Empty the water tank (7).
2. Place the iron on the steam station, standing on its heel, and lock the iron
with the fi xing lever (10).
3. Roll up the mains cable (5) and the supply hose (4) in the storage fi xing (6).
Do not wrap the cords too tight.
9
ENGLISH