When The Engine Is Cold; When The Engine Is Warm - Echo CS-310 Instruction Manual

Choke control knob
Choke
Starter handle
Choke control knob
Chain brake
Ignition
switch
Start / Run
Purge pump
Open choke
Chain brake

WHEN THE ENGINE IS COLD

Make sure the bar and chain are free from any obstruction
when starting the chain saw.
• Move chain brake lever fully forward to lock chain brake
before starting.
• Fill the fuel tank with fuel mixture. Do not over fill.
• Fill the chain oil tank with lubricant.
Do not over fill.
• Move ignition switch to "RUN" position.
• Push purge pump 3 to 4 times or until fuel is visible in
purge pump.
• Pull choke control knob all the way out. (Choke position)
NOTE
Do not pull starter rope out to the maximum possible
position.
Do not allow recoil handle to snap back against the cas-
ing.
• Securely hold the chain saw as shown and pull starter
handle several times until first firing sound.
• Push choke control knob all the way in.
• Pull starter handle to start the engine.
• When engine starts, immediately squeeze throttle trigger
to release throttle latch.
Do not increase engine speed while chain brake is locked.
NOTE
If engine does not start after 5 pulls, repeat instructions.

WHEN THE ENGINE IS WARM

Make sure the bar and chain are free from any obstruction
when starting the chain saw.
• Move chain brake lever fully forward to lock chain brake
before starting.
• Confirm there is fuel and chain oil in the tanks.
• Move ignition switch to "RUN" position.
• Securely hold the chain saw as shown and pull
starter handle.
• Choke may be used if necessary, but after first firing sound,
pull throttle trigger to release choke.
NOTE
If engine does not start after 5 pulls, use cold start proce-
dure.
17
CAUTION
CAUTION
CAUTION
CS-310