Preparation For Use - Echo CS-310 Instruction Manual

Dimple (D)
Kick Guard
Recess (E)
Nut (F)
CS-310

PREPARATION FOR USE

Bolt (A)
®
Rear hole (B)
Front hole (C)
Guide bar
Two nuts
Clutch cover
Saw chain is sharp! Always wear gloves when
handling assembly, otherwise serious personal
injury may result.
NOTE
The machine may be delivered with guide bar,
tip guard, and saw chain separated. Install
guide bar, tip guard, and saw chain as follows.
KICK GUARD TO BAR INSTRUCTIONS
®
Tools Needed: Two 11 mm (7/16 in.) Wrenches.
For saws with Kick Guard
Symmetrical Low-Kick type (Double Guard)
guide bars.
1. Install bolt (A) in rear hole (B) of Kick Guard
and through front hole (C) in guide bar.
2. IMPORTANT: Dimple (D) in Kick Guard
engage recess (E) in guide bar.
3. Tighten nut (F) and bolt (A) using 11 mm (7/16
in.) wrenches until snug. Make certain Kick
Guard is flush against guide bar.
®
4. Tighten nut (F) 1/8 additional turn.
5. Check to make certain Kick Guard
guide bar.
GUIDE BAR AND SAW CHAIN IN-
STALLATION/REMOVAL
1. Release the cylinder cover latches, and remove
the cylinder cover.
2. Remove spark plug lead.
3. Remove two clutch cover nuts and remove
clutch cover.
4. Remove bar and saw chain if necessary. See
"Maintenance and Care" section for guide bar/
saw chain maintenance procedures.
12
WARNING
P/N 2893201 and
®
must
®
is tight on
®
®