Cutting Instruction - Echo CS-310 Instruction Manual

CUTTING INSTRUCTION

Kickback
GENERAL
• Read t he E CHO " CHAIN S AW S AFETY M ANUAL" i ncluded w ith
your chain saw for additional cutting and safety instructions.
• Wear s uitable h earing p rotection s uch a s e armuffs o r e arplugs
to protect against objectionable or uncomfortable loud noises.
• Do not let the tip of the bar touch anything while
the engine is running. At cutting speed the chain is
moving at a high rate of speed. Should the tip contact
a limb or log while the chain is moving, the tip will be
pushed upward with considerable force.
This is known as kickback. Avoid it!
In all circumstances the operation of the chain saw is a one-man
job.
It is difficult at times to take care for your own safety, so don't as-
sume the responsibility for a helper as well.
After you have learned the basic techniques of using the saw, your
best aid will be your own good common sense.
The accepted way to hold the saw is to stand to the left of the saw
with your left hand on the front handlebar and your right hand on
the rear handle so you can operate the throttle trigger with your
right index finger.
Before attempting to fell a tree, cut some small logs or limbs.
Become thoroughly familiar with the controls and the responses
of the saw.
Start the engine, see that it is running properly.
Squeeze the trigger to open the throttle wide open and start the
cut. If the chain is properly sharpened, the cutting should be rela-
tively effortless.
It is not necessary to press down hard to make the saw cut.
Pushing the saw too hard will slow the engine and cutting will
actually be more difficult.
Some material may adversely affect the housings of your chain
saw.
(Example palm Tree Acid, fertilizer etc.)
To avoid housing deterioration, carefully remove all packed saw-
dust around clutch and guide bar area and wash with water. Coat
metal parts with light oil.
NOTE
Some material may adversely affect the housings of your
ECHO chain saw.
(Example: Palm Tree Acid, fertilizer, etc.) To avoid hous-
ing deterioration, carefully remove all packed saw dust
around clutch and guide bar area and wash with water.
Coat metal parts with light oil.
19
CAUTION
CS-310