When The Engine Is Cold - Echo CS-352 Instruction Manual

Choke control knob
Choke
Starter handle
Choke control knob
Choke
Starter handle
Chain brake
Ignition switch
Start / Run
Purge pump
Chain brake
Ignition switch
Start / Run
Purge pump
• After choke control knob is pulled and then knob
is returned to original position, throttle remains
slightly open (latch condition).
•The chain will attempt to rotate when
engine is started with throttle latch engaged.
•Do not start engine before chain brake is
activated.
• After starting the engine, squeeze throttle trigger
slightly to release throttle latch, otherwise brake
damage may occur.
• Never use throttle latch for cutting.
• Use the throttle latch only in starting.

WHEN THE ENGINE IS COLD

Make sure the bar and chain are free from any
obstruction when starting the chain saw.
• Move chain brake lever fully forward to lock chain
brake before starting.
• Fill the fuel tank with fuel mixture.
It is not permitted to fill fuel above the shoulder level
of fuel tank.
• Fill the chain oil tank with lubricant.
Do not over fill.
• Move ignition switch to "RUN" position.
• Push purge pump 3 to 4 times or until fuel is visible in
purge pump.
• Pull choke control knob all the way out. (Choke posi-
tion)
NOTE
Do not pull starter rope out to the maximum possible
position.
Do not allow recoil handle to snap back against the
casing.
• Securely hold the chain saw as shown and pull starter
handle several times until first firing sound.
• Push choke control knob all the way in.
• Pull starter handle to start the engine.
• When engine starts, immediately squeeze throttle trig-
ger, to release throttle latch.
Do not increase engine speed while chain brake is
locked.
NOTE
If engine does not start after 5 pulls, repeat instruc-
tions.
17
WARNING
CAUTION
CAUTION
CAUTION
CS-352