Connection To The Control Signal Terminal; Mouse Emulation - Dukane 28A8035 Operating Manual

Connection to the control signal terminal

1. Control signal terminal
Pin No. RS-232C
1
2
3
4
5
6 SELO
7 RTS
8
9
10 GND
11
12
13 RDP
14 TDP
15
Turn off the power of both the projector and computer before connecting.
Caution
Connect the computer to the control terminal of the projector using an appropriate cable.
Refer to the instruction manual of each device before connecting.

2. Mouse emulation

(1) Connect the projector and the mouse terminal of computer using an appropriate cable, while the
projector and the computer are turn off.
(2) Turn the main power switch of the projector on and press the STANDBY/ON button. The indicator
will light. (The ON indicator will light up green.).
(3) Press the INPUT of the projector or RGB button of the remote control transmitter and select the
input connection.
(4) Turn on the computer.
(5) Start mouse emulation mode.
If can not start mouse emulation, reset the computer. (With soft reset or reset switch)
(6) See on the page 9 about to operate the remote control transmitter.
Caution : Mouse cannot be operated while start up screen or menu screen is being displayed.
· In some note computers which have internal pointing device, mouse emulation don't work
Caution
without setting the internal pointing device disabled. In this case, set the internal pointing
device disabled in BIOS setting. After setting in BIOS, operate (1) ~ (5) Please check its
hardware manuals to disable internal pointing device in BIOS setting.
· In some computers, mouse emulation don't work without the utility program. In this case,
see and check the operating manuals of the computer.
Mouse
PS/2 ADB Serial
CLK
DATA DATA
SELO SELO
RTS RTS RTS
+5V +5V
GND GND GND
TD
1 5
6
11 15
D-sub 15pin shrink terminal (Male)
10
23