Connection To The Video Signal Terminals; Connection To The Rgb Signal Terminal; Input Signal - Dukane 28A8035 Operating Manual

Connection to the video signal terminals

1. Input signal

S-VIDEO signal
VIDEO signal
Input
AUDIO signal
Output
2. Signal input terminal
Video input signal terminals have priority in the following order.
Caution
S-VIDEO input terminal
1
Even when the video signal is displayed, only an audio signal is output to RGB audio output terminals.

Connection to the RGB signal terminal

1. Input / output signal
Video signal
Horizontal sync signal
Vertical sync signal
Composite sync signal
Input
Audio signal
Output
2. Signal input / output terminal
1 Video signal (Red)
2 Video signal (Green)
3 Video signal (Blue)
4 N.C
5 N.C
6 Ground (for R)
7 Ground (for G)
8 Ground (for B)
Do not use RGB cable other than that specified.
Caution
Some RGB cable may not operate DDC (Display Data Channel)
because there are not connect from pin NO.
20
Luminance signal
Chrominance signal 0.286Vp-p (burst signal), 75W termination
Chrominance signal
Ground
S VIDEO input (Mini DIN4 pin)
RCA jack input terminal
2
Analog 0.7Vp-p 75W termination (Positive polarity)
TTL level (Positive/negative polarity)
TTL level (Positive/negative polarity)
TTL level
200mVrms, 20kW below (MAX 3.0Vp-p)
0~200mVrms, 1kW
9 N.C
10 Ground
11 N.C
12 DDC (Display Data channel) RGB1 only
13 Horizontal/Composite sync signal
14 Vertical sync signal
15 DDC (Display Data channel) RGB1 only
1.0Vp-p, 75W termination
1.0Vp-p, 75W termination
200mVrms, 20kW below (MAX 3.0Vp-p)
0~200mVrms, 1kW
Luminance signal
Ground
to pin NO.
15 12
5 1
10
15 11
D-sub 15pin shrink terminal
(Female)
.
6