General Operation - Dual XD1222 Installation & Owner's Manual

XD1222 OPERATION
General Operation
Faceplate Removal
Press RELEASE and pull away from the left side to remove.
To re-install, insert right side of faceplate first then push left
side to secure.
Semi-permanent Faceplate Remove trim ring and install supplied #1 x 7/32" Phillips head
screw through left side of mounting frame into faceplate.
Installation
Press PWR to turn the unit on. Inserting a CD will turn the
Power On/Off
unit on automatically. Press PWR to turn the unit off.
Press MODE to select between AM/FM, CD or auxiliary input.
Mode
Modes of operation are indicated in the display.
Press and hold LOUD for 2 seconds to activate and deactivate
Loud
the loud feature. Activating this feature will enhance the
bass and treble frequencies when listening to music at low
volumes.
Insert a 3.5mm connector in the front panel AUX port.
Auxiliary Input
Connect the other end of the 3.5mm connector to the
headphone output of an audio device, MP3 player, etc. Press
MODE to select AUX mode.
Adjust volume using the rotary encoder (00-46).
Volume
Press DISP to display the clock. The radio frequency (tuner
Display
mode) and CD track/elapsed time (CD player mode) will be
shown by default.
Press DISP to display the clock, then release. Press and
Set the Clock
hold DISP for 2 seconds, the clock will begin to flash. Press
nn ll
TRACK to adjust the hours and TRACK to adjust
the minutes. Clock settings will be saved after 5 seconds.
The clock will display 12-hour AM/PM time in USA frequency
12/24-hour Clock
spacing mode (PM 10:00). In European frequency spacing
mode, the clock will display 24-hour time (22:00).
Press and hold for more than 2 seconds to RESET the unit
Reset
upon initial installation. The RESET button is located behind
the faceplate.
5