Programming The Remote To Control A Second Receiver In Aux Mode - Dish Network 167821 User Manual

P R
ROGRAMMING THE
R AUX M
ECEIVER IN
If you have another DISH Network satellite receiver installed, you can
use this remote in AUX mode to control it along with your new
receiver. When you program the remote to control the other receiver,
the remote sends out IR signals to the receiver. You can program the
remote to control any other DISH Network satellite receiver, except for
following:
• TV2 on Duo 322 (also known as DISH 322), DuoDVR™ 522,
DuoDVR™ 625, DuoDVR™ ViP
622 (also known as DISH Player-DVR models 522, 625, and
ViP 222, & ViP 622 DVR)
• DishPlayer 7100/7200
1
Turn on the other receiver and display the System Info screen (see
the receiver's User Guide for information on how to display this
screen).
Write down the address shown:
2 Press and hold the AUX button until all the other mode buttons
light up, and then let go of the button. The AUX button flashes.
3 Press the 3 button.
4 Use the NUMBER PAD to enter the address you wrote in
step 1.
5 Press POUND (#). The AUX button blinks three times.
6 Press RECORD to make sure the address and the remote matches
the address on the receiver.
8
C
EMOTE TO ONTROL A
ODE
®
222, and DuoDVR™ ViP
S
ECOND
®