Dish Network 167821 User Manual page 16

Instructions
4 Press POWER.
5 Press the UP or DOWN
ARROW repeatedly until
the equipment turns off.
6 Press POUND (#).
7 Turn the equipment back
on and try some other
buttons to make sure they
work.
8 If necessary, repeat this
procedure until you've tried
all the codes.
9
Once you find a code that
works, consider using
Limited Mode.
6
Additional Information
This puts your remote in the
scan mode.
As you press the UP or DOWN
ARROW, the remote tries each
code in the memory to see if it
can turn off your equipment.
When the equipment turns off,
you have found a code that
might work.
Note: The mode button for the
equipment flashes rapidly eight
times when you've scanned all
the codes for that equipment.
The mode button flashes three
times if you have entered the
code correctly. This stores the
code you found.
Press POWER to turn the
equipment back on. Try some
other buttons to make sure they
work. Sometimes POWER
works when other buttons
don't.
You may need to repeat the scan
to find the best code for your
equipment.
See page S-3, Placing Your
Remote in Limited Mode for
putting your remote in Limited
Mode.