Programming Using Equipment Code Tables - Dish Network 167821 User Manual

P U
ROGRAMMING SING
You can set up the remote to control other equipment using the
equipment codes listed on page 12 and the modes as shown on page 1.
Instructions
1
Turn the equipment on.
2
Find the brand name of the
equipment in the tables
starting on page 12.
3
Press and hold the mode
button until all the other
mode buttons light up, and
then let go of the button.
The mode button flashes.
4 For AUX mode only. Press
0 for a second TV, or 1 for a
second VCR, or 2 for a
tuner or amplifier.
5
Enter one of the three-digit
equipment codes from the
table using the number
buttons.
6 If you want to program
Limited Mode, press 1.
If not, skip to step 7.
7 Press POUND (#).
8 Press POWER to turn off
the equipment. If the
equipment does not turn
off, go to step 10.
4
E C T
QUIPMENT ODE ABLES
Additional Information
Use the equipment's front panel
buttons or its remote control.
If the brand isn't listed, see
Scanning for Equipment Codes
on page 5.
For example, hold the TV mode
button for a TV until all of the
other mode buttons light. When
you let go, TV flashes.
This step is for programming
the kind of equipment that
should be programmed in AUX
mode. If you're not
programming in AUX mode,
skip to step 5.
The three-digit equipment code
should be for the brand name of
your equipment that you found
in step 2.
See Limited Mode on page 3 for
more information.
If you entered the code
correctly, the mode button
flashes three times.
If the code works, the
equipment turns off.