Administration > Diagnostics; Administration > Factory Defaults - Linksys WRT160NL User Manual

Chapter 3
Log
Type Select Incoming Log, Outgoing Log, Security
•
Log, or DHCP Client Log.
<Type> Log
The Incoming Log displays a temporary
•
log of the source IP addresses and destination
port numbers for the incoming Internet traffic. The
Outgoing Log displays a temporary log of the local IP
addresses, destination URLs/IP addresses, and service/
port numbers for the outgoing Internet traffic. The
Security log displays the login information for the
web-based utility. The DHCP Client Log displays the
LAN DHCP server status information.
Click Save the Log to save this information to a file
on your PC's hard drive. Click Refresh to update the
log. Click Clear to clear all the information that is
displayed.
Click Save Settings to apply your changes, or click Cancel
Changes to clear your changes.
Administration > Diagnostics
The diagnostic tests (Ping and Traceroute) allow you to
check the connections of your network devices, including
connection to the Internet.
Administration > Diagnostics
Diagnostics
Ping Test
Ping checks the status of a connection.
IP or URL Address Enter the address of the PC whose
connection you wish to test.
Packet Size Enter the packet size you want to use. The
default is 32 bytes.
Number to Ping
Enter the number of times you wish to
test the connection. The default is 5.
Start Test To run the test, click this button. The Ping
screen shows if the test is successful. Click Close to return
to the Diagnostics screen. Click Stop to stop the test.
Wireless-N Broadband Router with Storage Link
Advanced Configuration
Diagnostics > Ping
Traceroute Test
Traceroute checks the performance of a connection.
IP or URL Address
Enter the address of the PC whose
connection you wish to test.
Start Test To run the test, click this button. The Traceroute
screen shows if the test is successful. Click Close to return
to the Diagnostics screen. Click Stop to stop the test.
Diagnostics > Traceroute
Administration > Factory Defaults
Restore the Router to its factory default settings.
Administration > Factory Defaults
NOTE:
Do not restore the factory defaults unless
you are having difficulties with the Router and
have exhausted all other troubleshooting
measures. Once the Router is reset, you will have
to re-enter all of your configuration settings.
Factory Defaults
Restore All Settings
To reset the Router's settings to the
defaults, click this button and then follow the on-screen
instructions. Any settings you have saved will be lost when
the default settings are restored.
28