Operation - Hilti TE 2-22 Original Operating Instructions

1. Push the accessory tool into the chuck as far as it will go, turning it and
applying light pressure until it engages with an audible click.
2. After fitting the accessory tool, grip it and pull it in order to check that it
is securely engaged.
▶ The product is ready for use.
5.7 Removing the accessory tool
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or
have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
1. Pull the accessory tool retaining bar back as far as it will go.
2. Remove the accessory tool.
5.8 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether
for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining
strap and the Hilti tool tether #2261970.
▶ Secure the retaining strap to the installation openings for accessories.
Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure
the second carabiner to a load-bearing structure. Check that both
carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap
and those of the Hilti tool tether.
6

Operation

Observe the safety instructions and warnings in this documentation and on
the product.
6.1 Switching on and off
1. To switch the product on, press the control switch.
2. To switch the product off, release the control switch.
*2266025*
5
2266025 English 13