Re-Adjustment Of Tools; Safety Systems; Troubleshooting - Bosch OptiMUM MUMPC33S00 Instruction Manual

Bread dough
Basic recipe
– 1000 g flour
– 3 sachets dried yeast
– 2 tsp salt
– 660 ml warm water
■ Mix all ingredients with the kneading
hook for approx. ½ minute at setting 1,
then for approx. 4-5 minutes at setting 3.
Maximum quantity: 1,5 x basic recipe

Re-adjustment of tools

W Risk of injury!
Pull out the mains plug before re-adjusting.
Caution!
Only re-adjust tools in small steps. It must
be possible to completely lower the swivel
arm, and when doing so, the tools should
not catch on the bottom or on the edge of
the bowl. The optimum distance between
the tools and the bowl is 3 mm.
X Image sequence K
■ Insert the professional stirring whisk and
check the current setting.
■ Press the release button and raise
the swivel arm to the stop.
■ Hold the tool with your hand. Release
the lock nut in a clockwise direction
using a spanner wrench (10 mm).
■ Adjust the distance to the bowl by
turning the tool (1 whole turn corre-
sponds to a height adjustment of 1 mm).
Turn anticlockwise:
Distance to bowl is reduced.
Turn clockwise:
Distance to bowl is increased.
■ Press the release button and push the
swivel arm down until it locks into place.
■ Check the tool distance. The optimum
distance between the tools and the bowl
is 3 mm. Adjust if necessary.
■ Once the distance is perfectly adjusted,
press the release button and move the
swivel arm back.
■ Hold the tool with your hand. Turn the
lock nut in an anticlockwise direction
using a spanner wrench (10 mm).
Re-adjustment of tools

Safety systems

Start lock-out
The appliance can only be switched on if
the bowl has been inserted and turned until
it locked into place, or if an accessory has
been secured to the main drive with the
bevel gear, and if the swivel arm is locked
into the lower position.
Automatic power-on safety lock
If the power is interrupted, the appliance
remains switched on, but the motor does
not start again when power is restored.
To switch back on, first turn the rotary
switch to y, and then switch on again.
Overload protection
The overload fuse will switch the motor off
automatically during operation. One pos-
sible cause may be processing too much
food at once.
Swivel arm protection device
The swivel arm will not unlock and move if
an accessory is fitted to the rear drive.

Troubleshooting

Note: The appliance will no longer
switch on if there is an error in appliance
operation, if the electronic fuses trip or the
appliance has a defect. First try to eliminate
the problem which has occurred with
the help of the following information.
Caution!
If a fault cannot be eliminated, please
contact customer service.
Fault
Appliance does not start.
Remedy
■ Check the power supply.
■ Check the mains plug.
■ Check the swivel arm.
Correct position? Locked into place?
■ Turn the bowl until the stop.
■ The automatic power-on safety lock is
activated. Turn the rotary switch to y
and then back to the required setting.
en
21