Dhcp Server Settings - D-Link DIR-412 User Manual

Section 3 - Configuration
DHCP stands for Dynamic Host Control Protocol. The DIR-412 has a built-in DHCP server. The DHCP Server will automatically
assign an IP address to the computers on the LAN/private network. Be sure to set your computers to be DHCP clients by setting
their TCP/IP settings to Obtain an IP Address Automatically. When you turn your computers on, they will automatically load
the proper TCP/IP settings provided by the DIR-412. The DHCP Server will automatically allocate an unused IP address from
the IP address pool to the requesting computer. You must specify the starting and ending address of the IP address pool.
Enable DHCP Check this box to enable the DHCP server on your
Server:
router. Uncheck to disable this function.
DHCP IP Address
Enter the starting and ending IP addresses for the
Range:
DHCP server's IP assignment.
Note: If you statically (manually) assign IP addresses
to your computers or devices, make sure the IP
addresses are outside of this range or you may
have an IP conflict.
DHCP Lease Time:
The length of time for the IP address lease. Enter the Lease time in minutes.
D-Link DIR-412 User Manual

DHCP Server Settings

40