Table of Contents
Advertisement
en Cleaning and servicing
Running the rinse cycle
1.
Use the function selector to select .
a The display shows the programme duration. You
cannot change the programme duration.
2.
Open the tank cover.
3.
Remove the drip tray and empty it.
4.
Slide the empty drip tray in fully.
5.
Remove and empty the water tank and drain any re-
sidual water.
6.
Rinse out the water tank thoroughly and fill it with
fresh water.
7.
Slide the water tank in fully.
8.
Close the tank cover.
9.
Press
.
a Water is pumped through the pipes.
a The time remaining counts down in the display.
a An audible signal sounds once this time has
elapsed.
Subsequent cleaning
Carry out the following steps after every descaling pro-
gramme or rinse cycle.
1.
Open the tank cover.
2.
Empty, clean and dry the drip tray and water tank.
3.
Turn the function selector to the zero setting.
a The process is complete and the appliance is ready
for use.
Emptying the drip tray
With the cleaning functions, the residual water is collec-
ted in the drip tray. Then empty and dry the drip tray.
ATTENTION!
Heat may damage the drip tray.
▶
Do not dry the drip tray in the hot cooking compart-
ment.
▶
Do not clean the drip tray in the dishwasher.
1.
Briefly press on the centre of the tank cover.
a The tank cover opens. The drip tray and water tank
can now be accessed.
30
2.
Remove the drip tray from the tank recess.
3.
Open the lid for the drip tray.
4.
Empty the drip tray.
5.
Insert the drip tray into the tank shaft and slide it in
fully.
Advertisement
Table of Contents
