Power Supply; Battery Eliminator (Optional); Battery Eliminator Support - Sony Ericsson W710 Installation Instruction, Mechanical

Hide thumbs Also See for W710:

2.7 Power Supply

A Power Supply according to Mechanical Equipment List may be used.

Set the output of the Power Supply as follows

•

Voltage: 3.8Vdc

•

Current: 2.0Amps

A Battery eliminator is to be used together with a power supply to power the phone.

Connect the cables from the battery eliminator to the power supply, red cable to positive

output terminal and black cable to negative output terminal.

In some situations, a device may be needed to hold the battery eliminator in place when

it is being used. The following is a set of simple instructions for making a support that

holds the battery eliminator in place during use.

1. Obtain a battery cover. (The battery cover is listed in the Mechanical Parts List.)

2. Cut off the bottom half of the battery cover using the dimensions specified in the

1/00021-1/FEA 209 544/601 B

Sony Ericsson Mobile Communications AB

picture below.

43 MM

Assemble the Battery Eliminator (Dummy Battery) and modified battery cover to

the phone. Make sure that the Battery Eliminator (Dummy Battery) and the

modified battery cover both mount correctly, easily, and that there is no

interference between the battery cover and the wires of the battery eliminator.

Installation Instruction, Mechanical

4(5)

Table of Contents

Z710