Label Printer; Power Supply And Jumper Cables (Optional); Instructions For Making A W550 Battery Eliminator Support (Optional) - Sony Ericsson W550c Installation Instruction, Mechanical

Hide thumbs Also See for W550c:

2.7

Label Printer

A Zebra printer (41) should be set up to print labels. Connect the printer with a Null Modem (42)

cable to the serial port on the computer (34). Read the Zebra installation manual for more

information about the installation.

2.8

1. Install the power supply (POS-77) according to the manufacturer's instructions.

2. Connect the jumper cables to the power supply's (POS-77) output terminals. Red (POS-88) to

the positive output terminal and black (POS-89) to the negative output terminal.

3. Connect the banana plugs of the red and black jumper cables to the battery eliminator's

(POS-52) red and black connectors.

4. Set the output of the Power Supply as follows:

•

3 Instructions for making a W550 Battery Eliminator

Support (Optional)

A device is needed to hold the battery eliminator in place when it is being used. The following is a

set of simple instructions for making a support that holds the battery eliminator in place during use.

1. Obtain a battery cover.

NOTE!

1/00021-1/FEA 209 544/96 A

Company Internal

Sony Ericsson Mobile Communications AB

Voltage: 3.8Vdc

Current: 2.0 Amps

The battery cover is listed in the

Mechanical Part List.

Installation Instruction, Mechanical

4(7)

Table of Contents

W550i