Controls / Settings; Timer Control; Ion Generator; Fan Speed Control - Therapure TPP640S Manual

Hide thumbs Also See for TPP640S:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 20
26
OPERATING THE THERAPURE
en

CONTROLS / SETTINGS

Power Control – To operate the Therapure
press the Power button to turn on the air purifier and
ionizer.

TIMER CONTROL

The Therapure
TPP640S air purifier can be pro-
®
grammed to turn off after a preset amount of time.
Press the "TIME" button to program the timer. Each
press will add one hour up to a total of 24 hours. Keep-
ing the button pressed will automatically increase to 24
hours, 1 hour at a time, after that it will turn back to off.

ION GENERATOR

The Ionizer is always on when the device is running.

FAN SPEED CONTROL

The Therapure
TPP640S has three different speeds of
®
cleaning, LOW, MED and HI. Press "SPEED" button to
cycle the settings and select the fan speed you desire.
The speed state will be shown on the LED display.

AUTO MODE

The Therapure
®
TPP640S is equipped with an air sen-
sor to monitor the quality of your air. Simply press the
"AUTO" button to activate the air monitoring system.
The monitor will test the air quality and automatically
adjust the fan speed to remove the air contaminants.
The front of the display is equipped with LED lights
to notify you of the air quality. RED color is for poor,
ORANGE for fair and BLUE for good quality air.
TPP640S
®

CLEAN FILTER INDICATOR LIGHT

TPP640S,
The Therapure
TPP640S Clean Filter Indicator Light
®
®
will turn on each time the filter needs to be cleaned.
To reset the filter indicator, press the ON/OFF and UV/
VOC buttons together for 3 seconds. The CLEAN FILTER
light will flash 3 times and then turn off completely,
indicating the unit has been reset.

DIM MODE

If the LED lights are too bright, activate the "DIM Mode"
to turn off the LED lights and the lighted display. To turn
on Dim mode, simultaneously press Auto and Time but-
tons. Power indicator, however, will remain lit.

UV CONTROL

Press the "UV/VOC" control button for UV/VOC to turn
on the UV lamp and the photocatalyst filter.
LED Light
Red / Orange / Blue

Advertisement

Table of Contents
loading

Table of Contents