Controls / Settings; Timer Control; Ion Generator; Fan Speed Control - Therapure TPP640S Manual

26
en

CONTROLS / SETTINGS

Power Control – To operate the Therapure® TPP640S,
press the Power button to turn on the air purifier
and ionizer.

TIMER CONTROL

The Therapure® TPP640S air purifier can be pro-
grammed to turn off after a preset amount of time.
Press the "TIME" button to program the timer. Each
press will add one hour up to a total of 24 hours.
Keeping the button pressed will automatically in-
crease to 24 hours, 1 hour at a time, after that it will
turn back to off.

ION GENERATOR

The Ionizer is always on when the device is running.

FAN SPEED CONTROL

The Therapure® TPP640S has three different speeds
of cleaning, LOW, MED and HI. Press "SPEED" button
to cycle the settings and select the fan speed you
desire. The speed state will be shown on the LED
display.

AUTO MODE

The Therapure® TPP640S is equipped with an air
sensor to monitor the quality of your air. Simply
press the "AUTO" button to activate the air monitor-
ing system. The monitor will test the air quality and
automatically adjust the fan speed to remove the air
contaminants. The front of the display is equipped
with LED lights to notify you of the air quality. RED
color is for poor, ORANGE for fair and BLUE for good
quality air.

CLEAN FILTER INDICATOR LIGHT

The Therapure® TPP640S Clean Filter Indicator Light
will turn on each time the filter needs to be cleaned.
To reset the filter indicator, press the ON/OFF and
UV/VOC buttons together for 3 seconds. The CLEAN
FILTER light will flash 3 times and then turn off com-
pletely, indicating the unit has been reset.

DIM MODE

If the LED lights are too bright, activate the "DIM
Mode" to turn off the LED lights and the lighted dis-
play. To turn on Dim mode, simultaneously press
Auto and Time buttons. Power indicator, however,
will remain lit.

UV CONTROL

Press the "UV/VOC" control button for UV/VOC to turn
on the UV lamp and the photocatalyst filter.
LED Light Red / Orange / Blue