Advertisement
TROUBLESHOOTING
Door does not open even
when moving the hand
towards the sensor.
Sensor stays in detection.
Door remains open after
detection/activation.
TECHNICAL SPECIFICATIONS
Technology
Radiated frequency
Radiated power
Radiated power density
Detection range (hand)
Detection mode
Speed of target to create detection
Supply voltage**
Power consumption
Output**
Max. voltage
Max. current
Output hold time
Temperature range
Degree of protection
Material
Wiring cable
* An adjustment of the detection field below 10 cm is possible but the detection capability of the sensor can not be guaranteed.
** External electrical sources must be within specified voltages, max 15W and ensure double insulation from primary voltages.
BEA SA | LIEGE Science Park | ALLÉE DES NOISETIERS 5 - 4031 ANGLEUR [BELGIUM] | T +32 4 361 65 65 | F +32 4 361 28 58 | INFO@BEA.BE | WWW.BEASENSORS.COM
BEA hereby declares that the MAGIC SWITCH CHROMA is in compliance with European Directives 2014/53/EU
(RED) and 2011/65/EU (RoHS).
The full text of the EU declaration of conformity is available on our website.
This product should be disposed of separately from unsorted municipal waste.
4
Bad or no power supply.
Detection range is too short.
Incorrect wiring / connection.
The environment influences the
good functioning of the sensor.
Incorrect wiring / connection.
Wrong output mode.
Incorrect wiring / connection.
Check power supply. If LED switches on or flashes,
power connection is OK.
Adjust the detection range.
Remove any metal plates in front of the sensor.
Check wiring and relay connection.
Remove any moving object around the sensor.
Check wiring and relay connection.
Switch the output mode to PULSE.
Check wiring and relay connection.
Microwave motion sensor
24.150 GHz
< 20 dBm EIRP
< 5mW/cm
2
+/- 10 to 60 cm if movement towards sensor at 90° (adjustable)*
Motion (bidirectional)
Min. 5Hz or +/- 3cm/s, Max. 200Hz or +/- 1.2m/s
12 - 24V AC +/- 10% (50 - 60 Hz)
12 - 24V DC +30% / - 10%
< 1.5W
Electronic relay (galvanic isolation - polarity free)
42V DC / 30V AC
100 mA
0.5s (in PULSE mode)
-20°C to +55°C
IP65 with front face and gasket mounted on a smooth surface
PMMA / PC
Front face is treated with biomaster silver biocide tested to ISO
22196:2011. Please use biocides responsibly.
Stranded cable up to 16 AWG - 1.5mm
Technical specifications are subject to changes.
2
Advertisement
