Ipv4 Filter - Bosch MIC inteox 7100i User Manual

58 en | Network
Metadata
You can enable multicast metadata here. The configuration follows the same pattern as for
video multicast, but without the streaming option.
Define a multicast address and define a port.
Audio
You can enable multicast audio for different encoders here. The configuration follows the
same pattern as for video multicast, but without the streaming option.
Define a multicast address and define a port for the different encoders.
Multicast packet TTL
A value can be entered to specify how long the multicast data packets are active on the
network. If multicast is to be run via a router, the value must be greater than 1.
IGMP version
Set the multicast IGMP version to comply with the device.
Click Set to apply the changes.
Some changes only take effect after the unit is rebooted. In this case, the Set button changes
to Set and Reboot.
10.6

IPv4 Filter

Use this setting to configure a filter that allows or blocks network traffic that matches a
specified address or protocol.
IP Address 1 / 2
Enter the IPv4 address that you want to allow or block
Mask 1 / 2
Enter the subnet mask for the appropriate IPv4 address.
2022-01 | 1.13 |
User Manual
MIC inteox 7100i
Bosch Security Systems