Using Paper Other Than The Recommended (Head Offset Adjustments) - Citizen CLP-7001 User Manual

1 Using Paper Other Than the Recommended
(Head Offset Adjustments)
The printer has already been factory-set to the proper print quality when using the
recommended label paper. If the print quality is inferior because of the different type of
paper, adjust the head offset as follows:
The relationship between the offset verification window and the
print head heating element is shown below:
a) Print head position for label
Heating
element
b) Print head position for tag
Heating
element
Offset adjustment screw (M3)
Offset verification window
Offset adjustment screw
Offset verification window
Offset verification
Offset adjustment
window
screw
44
(a) When using standard label,
slick,
paper
① Peeping through the
② Make fine adjustments,
(b) When using thick paper
a
(tag or other paper)
① Peeping through the
b
② Turn the offset
③ Make fine adjustments,
Chapter 3 Paper and Ribbon
craft or thermal
offset verification window,
adjust the head offset so
that it comes to the
center line (middle of the
three lines) by turning the
offset adjustment screw
with a screwdriver.
Turn the offset
adjustment screw two or
three turns
counterclockwise with a
screwdriver. (Factory set:
Two turns.)
checking the self-test print.
offset verification
window, adjust the head
offset so that it comes to
the center line (middle of
the three lines) by
turning the offset
adjustment screw with a
screwdriver.
adjustment screw two to
four turns clockwise with
a screwdriver.
checking the self-test
print.